- Getting Started
- Developer Guides
-
Report Author Guides
- Quick Start
- Report Designer Interface
- Report Viewer Interface
- Data Binding
- Report Configuration
- Report Themes
- Report Stylesheets
- Report Layers
- Report Parameters
- Interactive Reports
-
Report Items
- Common Properties
-
Data Regions
- Table
- Banded List
- List
- Tablix
-
Chart
- Plot
- Axes
- Legend
- Overlays
- Sparkline
- Bullet Chart
- Data Visualizers
- Supplemental report items
- Expressions
- Report Parts
- Master Reports
Customizing Gauge Plots
The following properties allow you to fine-tune the appearance of Gauge Plots, enabling greater control over their layout and presentation. You can explore these settings by adjusting the configuration in the Gauge Plot Demo to see their effects in action.
Inner Radius – Specifies the size of the central hole as a percentage of the outer radius.
Start Angle – Determines the rotation of the plot in degrees, measured clockwise. A full rotation is 360 degrees, allowing precise control over the initial position of slices.
Sweep – Controls the total arc length occupied by the plot, ranging from 0 to 360 degrees.